Useful Tips for How to Replace a Cutlass Bearing
The drive shaft log of any vessel has cutlass bearing which is made with brass and a grooved lining from the inside and which is lubricated by the water that penetrates the grooves when it is rotating, this.
It does not matter the number of times that you use your boat, but you must at some point change the cutlass bearing. When it is time to change that cutlass bearing, you will find the cutlass bearing a bit far from the keel or somewhere buried in the woodwork of the boat.
Fortunately apart from getting your hands dirty, removing the cutlass bearing is not tricky. Replacing your boat’s cutlass bearing can be done using the steps given in this article, now.
Locating and removing the set screws should be the first thing to do. The area where you will find the layer of crud and marine is where the set screws are hidden in most cases. Don’t forget that other boat manufacturers do not use set screws. If you already know that your boat does not have set screws, then it is not good to waste time looking for them.
Cutting the bearing is a must in the replacement of the cutlass bearing. If you don’t have a Sawzall with you, then a hacksaw should help you to cut the cutlass bearing. You should know that you need to have ample experience to be able to use the Sawzall tool from Propeller Depot safely.
Now to remove the cutlass bearing by bending it. Using a cold chisel and a hammer it is possible to bend the cutlass bearing to the inner side so that you get to the place where you have made the cut. If you want to bend the cutlass bearing avoid using a lot of force by hitting it. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.
Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. By so doing you may damage the strut’s inside.
Lastly, you can now remove the cutlass bearing. Do this with a pair of pliers to hold and remove the bearing. Now clean the surface of the strut and install a new cutlass bearing. After removing the old cutlass bearing, and the surface of the strut is clean, and you are about to install a new cutlass bearing bought from Propeller Depot ensure the cutlass bearing can enter the acme props in a straight line.
If the ramrod strut is not straight and if it is forced it may get damaged. So that the ramrod of the strut can go in straight use some grease on the cutlass bearing to help it to slide in easily.